D-MAX DVR Manuel d'utilisateur télécharger pdf (Page 74)

Chapter 5: Advanced setup

70 TruVision DVR 10 User Manual

Period 1 and enter the start and end time periods for the selected day. Each day

can have up to four time periods.

Repeat for each day of the week. If the desired times for this alarm output are

identical to those for other days, click Copy To and specify the day of the week to

which you want to copy this schedule. Select All if the same schedule is used all

week. Click Copy.

4. Click Confirm to save your settings and return to the Alarms screen.

5. Copy the alarm output settings to another alarm output if required.

To copy the settings to another alarm output, select an alarm output on the Copy

to Alarm Out list box then click Copy. A confirmation message displays. Select OK

to accept.

6. Click Confirm on the Alarms screen to save your alarm output settings.

Note: The TVR 10 will prompt you to reboot in order for the schedule to take

effect.

Notifications

Notifications refer to internal errors that occur within the system. Table 18 below

provides a list of these exceptions.

Table 18: List of exceptions

Condition When alarm occurs

HDD full Hard drives are full. Notification only occurs if you disable overwrite.

Hard disk error An error occurred in the hard drive.

Illegal access Log on failed on the unit.

IP address conflict Two devices on the network have the same IP address.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 111 112

Pas de commentaire

D-MAX DVR Manuel d'utilisateur Page 74